Maritim radio

IC-F61M

Compact and Waterproof Maritime Onboard Radio

Conforms to Maritime UHF onboard communication requirements
The IC-F61M is especially developed for onboard communication and is pre-programmed with 9 UHF onboard channels*. Icom has also matched this radio's electrical specifications with the strict requirements of EN 300 720-2.

* 25kHz channel.
IP67, dust-tight and water-proof construction
The IC-F61M has outstanding protection against dust and water which is equivalent to IP67. The IC-F61M can withstand submersion in 1m depth of water for up to 30 minutes and has dust-tight construction that prevents the ingress of dust.

Compact body
The IC-F61M's compact dimensions of 56 (W) × 97 (H) × 36.4 (D) mm allow the IC-F61M to fit comfortably in your palm or shirt pocket.

Lithium-Ion battery pack standard
With the supplied 1700mAh Lithium-Ion battery pack, BP-227, the IC-F61M provides stable output power and a practical 9–10 hours* of operating time.

* Typical operation; Tx:Rx:Stand-by duty cycle=5:5:90
Built-in signalings
Without installing an optional logic board, the IC-F61M has 5-Tone, CTCSS, DTCS signaling capabilities* for group communication or selective calling.

* Ask your dealer for programming these signalings.
700mW audio output power
The IC-F61M uses a BTL (bridge-tied load) amplifier that doubles the audio output. As a result, it delivers 700mW of loud audio*.

* Internal speaker only.
Vibration alert function
When a pre-programmed 5-Tone signal is received, the vibration alert function alerts you by vibrating the radio. The vibration patterns are also programmable (4 patterns × one time/repeat).

Max. 8 minute voice recorder
The built-in the voice recorder records incoming calls up to a maximum of 8 minutes (Or up to 48 calls of 10 sec. recording time). When a pre-programmed 5-Tone signal is received, the voice recorder automatically starts recording the message.

Other features
•2-step low battery alert
•Priority scan and dual priority scan
•Mode dependent scan
•Lone worker function
•Optional waterproof speaker microphone, HM-169 (IP57)
•Built-in audio compander
•Optional VOX headset available
•BTL only version (no vibration alert and no voice recorder) and BTL/Vibration alert version (no voice recorder) available*
* Not available in some countries.

Tillbaka

Specifikationer
Datablad

Frequency range			457.525–467.575MHz
Number of operating channels			9 UHF onboard channels (25kHz channel)
Channel spacing			25kHz
Current drain (at 7.2V DC)	Tx	2W ERP output	1.0A
	Tx	0.2W ERP output	0.4A
	Rx	AF Max.	500mA (Internal SP) 300mA (External SP)
	Rx	Stand-by	85mA
Operating temp. range			–20°C to +55°C
Dimensions (projections not included; W×H×D)			56×97×36.4 mm
Weight (approx.)			284g (with BP-227)

TRANSMITTER

	IC-F61M
Output power	2W ERP/0.2W ERP
Spurious emissions	0.25μW
Adjacent channel power	70dB

RECEIVER

		IC-F61M
Sensitivity (at 20dB SINAD)		–4dBμ typ. emf
Adjacent Ch. selectivity		73dB typ.
Spurious response		70dB
Intermodulation rejection		70dB typ.
Audio output power (at 5% dist. with an 8Ω load)	Internal speaker	0.7W typ.
Audio output power (at 5% dist. with an 8Ω load)	External speaker	0.5W typ.

Applicable U.S. Military Specifications

Icom makes rugged products that have been tested to and passed the following MIL-STD requirements and strict environmental standards.

Standard	MIL-810 F Method, Proc.
Low Pressure Storage	500.4 I
Low Pressure Operation	500.4 II
High Temperature Storage	501.4 I
High Temperature Operation	501.4 II
Low Temperature Storage	502.4-3 I
Low Temperature Operation	502.4-3 II
Temperature Shock	503.4 I
Solar Radiation	505.4 I
Rain Blowing	506.4 I
Rain Drip	506.4 III
Humidity Induced	507.4
Salt Fog	509.4
Dust Blowing	510.4 I
Vibration	514.5 I
Shock Functional	516.5 I
Shock Transit Drop	516.5 IV

Also meets equivalent MIL-STD-810-C, -D and -E.

Ingress Protection Standard

Dust and Water	IP67(Dust-tight and waterproof protection)

Ladda ner